Ricatech RMC150 Instructions d'exploitation télécharger pdf (Page 7)

ADVERTENCIA:

PARA EVITAR RIESGO DE INCENDIO O DE DESCARGAS

ELÉCTRICAS, NO EXPONGA ESTE APARATO A LLUVIA O HUMEDAD.

NO QUITE LA CUBIERTA. LOS PILOTOS LUMINOSOS ESTÁN

SOLDADOS EN SU LUGAR. NO HAY PIEZAS ÚTILES EN SU

INTERIOR. EN CASO DE REPARACIONES, ACUDA SIEMPRE A

PERSONAL DE REPARACIONES CUALIFICADO.

Especificaciones

Rango de frecuencias : MW 522 - 1620 KHz

: FM 87.5 - 108 MHz

Puerto USB 2.0 : VelocidadÊmáxima 512MB -4GB

(Soporta FAT16, FAT32)

Consumo de energía : 18W

Antenas : Cable de antena externo para FM

: Antena de ferrita incorporada para AM

Corriente eléctrica : AC 230V ~ 50Hz

Tamaño del altavoz : 2 x 3” de tipo dinámico

Ohmios del altavoz : 4 ohm

Vatios del altavoz : 5W

Salida de corriente : 2W x 2

*DISEÑO Y ESPECIFICACIONES SUJETOS A CAMBIOS SIN PRECIO AVISO.

El signo de exclamación

dentro de un triángulo

equilátero pretemde advertir

al usuario de la presencia

de instrucciones de

funcionamiento

(reparaciones) importantes

en el manual que acompaña

el aparato.

RIESGO DE DESCARGAS

ELÉCTRICAS. NO ABRIR

ADVERTENCIA

El símbolo del relámpago

con punta de flecha dentro

de un triángulo equilátero

pretende advertir al usuario

de la presencia de "voltaje

peligroso" sin aislar dentro

del producto. que puede

tener la suficiente magnitud

como para suponer un riesgo

de electrocución para las

personas.

ADVERTENCIA: PAPR REDUCIR

EL RIESGO DE DESCARGAS

ELÉCTRICAS, NO RETIRE LA

CUBIERTA (NI LA PARTE

TRASERA) NO HAYPIEZAS QUE

PUEDA USAR EN SU INTERIOR.

EN CASO DE REP ARACIONES

ACUDA SIEMPRE AL SERVICIO

TÉCNICO.

ESPAÑOL

TROUBLESHOOTING

There is no power

1. Make sure radio is plugged in correctly.

2. Look at the STAND BY INDICATOR (3) and check to see if it is red.

3. If the red light is on, press the POWER button (12/29) to turn the unit on.

There is no sound

1. Make sure the mute function is turned off.

2. Check that the volume is turned up by pressing VOLUME UP button (56) on the remote.

Note: Volume range on some units start at level 15 and ends at level 40.

3. Make sure INT./EXT. switch (18) on back of radio is switched to INT. (Unless you are using external speakers, in which case it

should be on EXT. )

4. Check to make sure power is turned on.

CD does not play

1. Check to make sure CD is inserted correctly (label side facing up).

2. Check to see that surface of CD is clean.

3. Make sure function switch is set to CD mode.

USB - There is no music playing when PLAY/PAUSE (USB) is pressed.

1. Make sure the MP3 device/Flash Drive has stored music files.

2. The unit will only play Flash Drives up to 512 – 4096 Bytes

3. Reset USB by switching the unit Off or switching to another Mode.

4. Check if the file(s) is WMA file(s). The unit does not play WMA format, only MP3 format.

Remote not working

1. Replace batteries.

2. Be sure to point the remote towards remote sensor when operating.

3. Remove obstacles in the path of the remote and radio so the remote signal has a straight path to the radio.

Turntable will not work

1. Check it the AC Power source is connected.

2. Press the POWER button (12/29) (on front of unit or on RC) to turn the unit on, the STAND BY INDICATOR (3) light should be

off.

3. Check that the unit is in PHONO Mode. Try moving the Tone Arm (26) to the right until a click is heard.

No Sound is coming from the unit

1. The white protective needle cover has not been removed

2. The Volume is not turned up

The Tone Arm will not move

1. The black tie-wrap has not been removed from underneath Tone Arm (26).

2. Tone Arm hold down clip has not been released

Trademarks – MPEG Layer-3 audio coding technology licensed from Fraunhofer IIS and Thomson

ENGLISH

1 2 3 4 5 6 7 8 9 10 11 12 ... 28 29

Commentaires sur ces manuels

Pas de commentaire

Ricatech RMC150 Instructions d'exploitation Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Platines audio Ricatech RMC150